Forum

[patrick659]

I made some work to the plane. I work onto another project
i want to return back to the plane project the image reference does not come back with the model ?

[craouette]

did you move the reference image? or the A3D file?

Craouette

[patrick659]

Hello
I did not move anything. I just exit from albatross and after i want to try the materials so i made a new running of albatross i made some mat.
and when i went back to albatross for working with the plane i just see that i did not have anymore the reference file with the modele.
More i use the ref image more is easiest but unfortunatly each time we left and go back we have to set up again the image with the model.
I work normaly with 4 windows 3 with the ref image and one without in this one i can zoom rotate pan for making selection of vertice ,edge and face.
It will be good also to have full screen for screen 2 ,3,4 in this way for very long or large image it will be easiest to make the setup image /model. Also for given an angle to the image it is by 1° and it will be good to have .5°.
Have a good time
Patrick