Forum

[DarkScythe]

Hi there,

i tried to play with the projector and uv projector, I selected all the face that fronting my view and then select uv edge the selection will convert to uv edges then hit split but when I tried to move the uv it is still connected, I found out that it only works per face then you can assemble it later.

If you can split a group of uv or multiple selected uv then I think it is a subtitute for uv unwrap.

Thnks.

[DarkScythe]

Funny I able to split group of selected uv's with a cylinder.

[DarkScythe]

I try it again and I able to split group of selected uv's but you have to select to face mode again to move it.
Now probably you can unwrap, I still to figure out the steps.

Thnks.

[craouette]

DarkScythe,

The split tool is intended for uv edges.
Select some connected edges. Press the split button.
Each selected edges will be double, one for each corresponding faces.

Hope this help,

Craouette